One cornerless tubular space frame chassis manufactured from 38mm
outside diameter x 2mm wall thickness mild steel. A 50mm o/d back
braced roll over bar with seat belt anchorages is incorporated in
the chassis. Pick up points for the steering rack, front and rear
suspension and rear sub frame are integral parts of the chassis as
are the engine mountings and steering support. The chassis is fully
welded and sleeved internally at the joints. For safety, the chassis
design has key members well ahead of the front suspension and well
behind the occupants.
Steering and Suspension Components
Steering rack and shaft
Track rod ends (pair)
Front springs (pair)
Front shock absorbers (pair)
Phosphor bronze bush tubes (pair)
Two top swivels Two chrome shaft locators
Steering column support bracket
Lower spring seats
Steering column bush bracket
Shock absorber brackets
Mild Steel Pre-cut and Folded Outer Panels
Two body sides
One rear panel
Two rear wing panels
Left and right hand louvred bonnet panels
Nose cone panels (pair) and filler panels Rear crescents, pair Two
bulkhead side panels
Bonnet rear strengthener (bent double)
Servo mounting panel
Set of GRP Panels
Front nose
Front cycle wings (pair)
Rear wheel arches (pair)
Set of Mild Steel Inner Panels
Floor
Seat back panels
Firewall panels
Feet panels
Tunnel sides and top
Windscreen Components
Toughened glass windscreen (BS Kite marked)
Two piece aluminium frame
Glazing rubber and T Seal
Windscreen pillars (pair)
Wiper blades
Exhaust Components
One complete twin tube exhaust system and baffle
Stainless steel exhaust heat protector
Light Set (E marked)
Chrome headlamp units (pair)
Sealed beam units (pair)
Front flasher lamps (pair) and bases
Number plate lamp
Rear combination lamps (pair)
Rear fog lamp
Side repeater lamps (pair)
Interior Components
Mountney 11" leather rimmed steering wheel
Mountney steering boss
Dashboard panel with pre-cut apertures
Perspex for instruments
Cockpit carpet
Length of vinyl
Cockpit edge finishing material
Snap on edge trim
Tin of glue
Miscellaneous
Radiator
Universally jointed propshaft with grease nipples
Set of three metal brake pipes
Fuel cap
Demister vents
Cycle wing brackets
Stainless steel stone guards and beading
Set of bonnet catches
Bonnet catch safety rail
Bonnet corner strengtheners Bonnet edge trim
Nose cone grille and badge
Rrear wing piping
Under floor strengthener section
Handbrake angle
'P' clips
Spare wheel bolt
Tube of silicone sealer
General fastener pack
Pair of gloves
Instruction video (12 hours)
In addition I have opted for these additional
components :
Pair of rear springs and shock absorbers
Four point Sabelt harnesses (SVA correct)
Set of four, 5 spoke alloy wheels with nuts
Pair of top quality, Recaro seats
Stainless steel exhaust silencer (replacement part)
Stainless steel 4 into 1 performance exhaust manifold Four flexible
brake pipes
Number plate lamp bracket
Pair of mirrors (SVA correct)
Reversing lamp
Hand brake cable
Washer bottle and pump
Stainless steel body panels
|